@TB Support

Do you have the code needed in the MFP JS afterrender section to re-load the pagination and results at the bottom of the page?

Currently, when you filter products using MFP, if the number of results > OC default products per page you get the following as an example:

For a selected filter that yields 36 total product results @ 18 per page
-No pagination
- Results section shows as: “Showing 1 to 1 of 1 (1 Pages)”

Also, the way that SEO and layout is handled with MFP may be affected by BurnEngine somehow. If you add MFP to ~/product/special and activate a filter (such as ~/product/special/mfp/stock_status,7):

- BurnEngine product layout rules are not accounted for (products per row set to 4 now shows as 2 products per row if only 2 results, 1 product per row if only 1 result, etc.) when it should show the product layout as it would normally appear – and as it tends to do on regular categories.

- You cannot refresh the page. If you refresh the page after applying a filter, you see the header and footer areas, however, the content section only shows as “The page you requested cannot be found.” (PLEASE NOTE: If this is TRULY a 404 page, it’s not showing the normal 404 page that it should as set in BurnEngine page builder). If you try to press the browser back button to go back to ~/product/special without any filters applied, the same “The page you requested …” is shown on the page, however, if you refresh that page, it shows the page normally.

I know that this must seem like a lot to try and decipher about what exactly is happening, so I made this quick little video to demonstrate what is happening:

http://www.screencast.com/t/8PRxmmH2aamS

Thanks!